Navlink Blue (Bluetooth, Ruuvi, Vakaros, etc.)
6 Docs
Using NAVLink Blue with NMEA Remote App
Last Updated: September 15, 2025NAVLink Blue will not appear in a conventional Bluetooth pairing screen because it supports a specific standard. Ensure NAVLink Blue is in BT mode. Then open NMEA Remote on your iPhone or iPad. Tap Menu, then Settings (by clicking on “NMEA Remote” at the top of the menu). Navigate to NMEA > Sources > Edit...
How to Switch from Server Mode to Client Mode in Navlink Blue
Last Updated: March 31, 2026The NAVLink Blue can be used in two modes: Server mode: used to connect to Vakaros Atlas 2 or NMEA Remote application. In this mode you can’t connect to other devices Client mode: used to connect to external sensors (Calypso, Ruuvi Tag and water presence sensors) By default, the NAVLink Blue will start in Server...
Connecting External Sensors to NAVLink Blue: Setup Guide
Last Updated: March 31, 2026For all sensors described in this document, only the pairing procedure with the NAVLink Blue is covered. For detailed information regarding installation, calibration, and operation of the sensors, please refer to the manufacturer’s user manual for each device. The NAVLink Blue can be used in two modes: Server Mode used to connect to Vakaros Atlas...
Connecting a RuuviTag to NAVLink Blue
Last Updated: March 31, 2026To connect a RuuviTag sensor, go to the Bluetooth page. If the RuuviTag is detected, it will appear in the Unregistered Devices section. If you do not see the RuuviTag, please follow the Ruuvi pairing process and check the device using the Ruuvi mobile application. Note that when the device is shipped, a battery isolation...
Connecting a Calypso wireless wind instrument to NAVLink Blue
Last Updated: March 31, 2026To connect a Calypso Wireless Wind Sensor, go to the Bluetooth page. If the Calypso sensor is detected, it will appear in the Unregistered Devices section. If you do not see the Calypso sensor, please follow the Calypso pairing process and verify the device using the Calypso mobile application. IMPORTANT: The sensor will not connect...
Connecting a water presence sensor to NAVLink Blue
Last Updated: March 31, 2026You can connect a water presence sensor to the NAVLink Blue. Go to the Bluetooth page and add the device named MSL01 Leak. You will be prompted to change the device name. You can either keep the default name or assign a custom name (e.g., “Engine Room”) to better identify where water is detected. This...